G1 GAMECHANGER MODULE - THUMB AND BUTTON VERSION

In order to update the firmware, by putting the Gamechanger Module in Bootloader mode, one must do the following:

1. Connect the turned off gamechanger module to a Windows equipped laptop with the supplied charge/data cord.

2. Have the .zip file you have downloaded from this product page and extracted to three files.

3. For simplicity, open only Windows Explorer on the computer and nothing else. Cannot use a Apple laptop as this is a Microsoft based USB flashing format.

4. In order to trigger bootloader mode, the gamechanger module needs to perform a full bootup after six interrupted bootups. The analogy I can provide you is cycling your car ignition without starting the engine. A interrupted bootup is a bootup terminated before the bootup song ends.

5. Step 4 done correctly, the seventh UNINTERRUPED bootup, the module will beep seven times, then a new drive show up in Windows Explorer called G1_BOOT on the next available drive letter

6. In this drive you will overwrite the three files with the three new files downloaded in the zip provided from this link..

7. File transfer takes no more than one second. Done right, it will all the necessary formatting changes to your memory.

WARNING: DO NOT PUT THIS FIRMWARE ON ANYTHING OTHER THAN THE GAMECHANGER MODULE AS OTHER UNITS DO NOT HAVE THE SAME COMPONENT COMBINATION