Calibrating your remote set so the numbers match on the machine to the hand remote
First step is to ensure both units, the receiver and hand remote are both off and not running.
Turn on the receiver by either plugging it in, or pressing the on switch (depends which model you have) and letting it bootup (10 sec)
While holding the bottom button, turn on the hand remote with the dial in the middle and once you see any leds lit on the screen, you can let go of the button.
At this stage, rotate the dial to confirm you have numbers displayed on the hand remote.
IF so, sweep from max to min repeating until screen dims. What I mean is when you go to max, ensure you see the max number and vice versa.
It will say ‘set min value’
You rotate the dial until it shows 4. Then press the up button.
It will say ‘set max value’
You rotate the dial to min which should show 5. Then press the up button.
Done correctly, it will say “calibrate, normal, min calibrate:”
You enter the desired low calibration number, press the up button.
It will say “refine”, you repeat step #11.
It will say “max calibrate:”
You enter the desired high calibration number, press the up button.
It will say “refine”, you repeat step #14.
Done right, it will say “end calibration”